The items listed below will assist in troubleshooting when
a problem occurs. As a first step, check all wiring connector
connections and verify AC power to the machine.
TABLE 1: TROUBLESHOOTING
| PROBLEM | CAUSE | COUNTERMEASURE |
| When the main SW is turned | The cord is not plugged in. | Firmly insert the plug into the outlet. |
| ON, the machine is not | Incorrect power source/voltage. | Make sure that the power supply |
| activated. | voltages are correct. | |
| Primary or secondary fuse | First, remove the cause of | |
| blown. | overcurrent, then replace the fuse. | |
| Primary Fuse: 5A 250 V Slo Blo | ||
| Secondary Fuse: 5A 250 V Slo Blo | ||
| MONITOR screen is blackened | Primary or secondary fuse | First, remove the cause of |
| and the fluorescent lamp does | blown. | overcurrent, then replace the fuse. |
| not light up. | Primary Fuse: 5A 250V Slo Blo | |
| Secondary Fuse: 5A 250V Fast Blo | ||
| MONITOR screen is all blue. | Defective connections between | Make sure of correct connections |
| boards. | between boards. | |
| The color of image on | Incorrect monitor adjustment. | Make appropriate adjustments. |
| MONITOR screen is incorrect. | RGB connections are mixed up. | Reconnect RGB cables correctly. |
| The on-screen image of the | The power source and voltage | Make sure that the power supply |
| monitor sways or shrinks. | are not correct. | voltages are correct. |
| Handle Mecha and bike body | Poor VR setting. | Perform VR setting. |
| operation is not satisfactory. | VR deviation or malfunction. | Adjust or replace the VR. |
| Poor mesh of Adjust Gear | Adjust "Adjust Gear" mesh. | |
| Spring fault due to secular | Replace spring. | |
| change of throttle and brake | ||
| mechanism. | ||
| With Manual transmission, shift | Shift SW malfunctioning. | Replace SW. |
| operation is not satisfactory. | ||
| During game, no bike body | Power On check is not | Redo power input and complete |
| reaction, or irregular | satisfactory. | Power On check |
| functioning. Game start does not | Poor connection or malfunction | Perform drive board test. |
| unlock the bike. | of the motor driver and drive | Check for connection between |
| board. | motor, motor driver, drive board and | |
| game board. | ||
| Overheat of motor. | Turn power off and allow motor to | |
| cool before restoring power. | ||
| Bike body centering is incorrect. | VR setting fault. | Perform VR setting,. |
| VR deviation or malfunction. | Adjust or replace the VR. |
Continued on next page.