STOP: IMPORTANT!

Although Remote Control Buttons other than those specified below do not function even if pressed during Convergence Adjustment, do not press them during adjustment work so as to avoid causing malfunctioning.
Operate the Remote Control towards the PTV screen. If directed other than to the PTV screen, the Remote Control does not function.

BEFORE USING THE REMOTE CONTROL:
First make sure that the main SW on the Projector's control panel is ON (the LED adjacent to the main SW is lit).

For the Convergence Adjustment mode, press the test button (Figures 1 - 5 below). Ensure that "R" is displayed on the screen.
Make adjustment so as to cause the red cross pattern to match with the green cross pattern. When the red cross matches the green cross, the green cross turns yellow or white (Figures 2 - 3 - 4 below).
Use remote control buttons shown below to move the red cross as follows:
Button (5) .......... to the left.
Button (7) .......... to the right.
Button (2) .......... Upward.
Button (10) ........ Downward.
Use Remote Control button (6) to shift "R" to "B." Make sure that "B" is displayed on the screen. Each time Button (6) is pressed, red and blue adjustments are shifted.
In the same manner as in (2) above. cause the blue cross to match with the green cross. When the blue cross matches with the green cross, the green cross turns white.
After adjustment is made, press the test button (Figures 1 - 5 below) to cancel the Convergence Adjustment mode.

* When 2 minutes or more elapses in the Convergence mode screen without taking any action, the on-screen adjustment mode will disappear.