THROTTLE/BRAKE VR REPLACEMENT
For VR replacement, turn the VR shaft to the periphery of the
VR shaft angle in which the VR value is the minimum, engage the
gears and secure the VR bracket. At this time, make sure the throttle
and brake are not applied respectively to the grip and brake lever.
Game is playable satisfactorily if the VR shaft rotates without
any problems within the mobile range of the grip and lever.
- Take out the 2 screws which secure the VR bracket to remove
the bracket from the handle unit.
- To remove the pinion gear, loosen the 2 set screws of the
pinion gear attached to the shaft of the VR to be replaced.
- Take out nut A from the VR shaft to remove the VR from the
bracket.
- After replacement, reassemble by reversing the above directions.
- In test mode, perform VR setting.
