INPUT TEST
Selecting INPUT test causes the screen shown to appear and
allows each switch status and game play related V.R. values to
be checked. Also, in this mode, V.R. value setting can be performed.
On this screen, periodically check the status of each switch &
V.R.
- By pressing each switch, if the display on the right-hand
side of the name of each switch changes from ON to OFF, the SW
and the wiring connections are satisfactory.
- To check CHUTE 1 & CHUTE 2 coin switches, open the COIN
CHUTE DOOR and insert a coin(s) in the slot.
- To return to the MENU mode, press the TEST BUTTON.
VR SETTING PROCEDURE
- While pressing the SHIFT-UP button, press the START button
to select the desired change item. Release the button to make
the selection effective.
- With the SHIFT-DOWN button pressed down, move the applicable
device for shifting (throttle, brake and bank) fully within the
applicable mobile range to set the value. When setting the bank
V.R., where the button is released will be the center position.
- Upon finishing the setting change, press the TEST button
to return to the screen.
APPROPRIATE VALUE FOR EACH V.R.
To change V.R. securing position when replacing the V.R., etc.
first secure the V.R. at a position displaying the following values.
Then, perform V.R. setting in the above mentioned procedure.
| THROTTLE: |
MIN. 20H (without turning the THROTTLE GRIP) |
| BRAKE: |
MIN. 20H (without pulling the BRAKE LEVER) |
| BANK: |
MIN. 10H |
<--80 H--> |
MAX. F 0 H |
|
when inclined right |
center position |
when inclined left |