[Table of Contents] [Previous Page] [Next Page]
SHIFT LEVER GREASING AND SWITCH REPLACEMENT

Grease the shift lever every three months. If the shift lever values cannot be set appropriately in Test Menu, replace the shift lever's switch.

REMOVAL
  1. Remove the four tamperproof screws that secure the shift lever to the control panel (see Figure 64).
  2. Disconnect the connector that connects the shift lever cable to the cabinet wiring harness.

GREASING
  1. Apply lubricant to the area shown in Figure 65 once every three months.
  2. Use NOK KLUBER L 60 or Grease Mate (Part No. 090-00609).
SWITCH REPLACEMENT
  1. Disconnect the wiring connector of the shift lever cable to the affected switch (see Figure 66).
  2. Remove the two tapping screws that secure the switch to the shift lever.
  3. Replace the malfunctioning switch with a similar switch (Part Number 95-4276-00).
  4. Replace the tapping screws.
  5. Replace the shift lever cable.

SHIFTER REPLACEMENT
  1. Connect the shift lever cable to the cabinet wiring harness.
  2. Set the shift lever assembly into position, ensuring that the "DOWN" label is on the upper section of the shift lever.
  3. Replace the four tamperproof screws.