[Table of Contents] [Previous Page] [Next Page]
DRIVE BOARD DIP SWITCH SETTINGS

If the Steering Wheel Centering Level cannot be set satisfactorily using the Output Test menu, the Drive Board DIP switch settings may need to be changed.

  1. Open the underseat cabinet on the same side as the affected steering wheel.
  2. Remove the three slotted screws that secure the Shield Case lid and remove the lid (see Figure 56).
  3. The Drive Board is located as shown in Figure 48, and the DIP switches are located as shown in Figure 57.
  4. Change the settings on DIP switch 1, switches 1-3, per Table 22.
  5. Leave the remainder of the DIP switches set as they were.
  6. Replace the Shield Case lid and replace the three screws.
  7. Close the underseat cabinet.
  8. Set the variable values in the Control Range ("Volume") menu.
  9. Close the rear access panel.



FIGURE 56: DRIVE BOARD LOCATION