ASSEMBLING THE MACHINE
WARNING!
When moving or lifting the INDY 500 TWIN game cabinet over surfaces
of differing levels (steps and stairs), separate the left- and
right-hand sides before moving the cabinet. Moving or lifting
the cabinet while the left and right sides are connected may cause
damage to the cabinet.
UNCRATE LEFT-SIDE CABINET (CRATE #1)
- Move shipping crate #1 containing the left-side cabinet into
location near the final installation location while still on
the pallet.
- Carefully remove the shipping bands, and top and sides of
the crate.
- Lift the left-side cabinet out and set on its casters.
- Roll the left-side cabinet into its approximate installation
location. Note: The left-side cabinet has the power cord and
the On/Off switch.
UNCRATE RIGHT SIDE CABINET (CRATE #2)
- Move shipping crate #2 containing the right-side cabinet
into location near the final installation location while still
on the pallet.
- Carefully remove the shipping bands, set aside crate #3,
and remove and top and sides of crate #2.
- Lift the right-side cabinet out and set on its casters.
- Roll the right-side cabinet into its approximate installation
location.
UNCRATE CASH BOX TOWER AND BILLBOARD (CRATE #3)
- Move shipping crate #3 containing the Cash Box Tower and
the Billboard into location near the final installation location
while still on the pallet.
- Carefully remove the shipping bands, and top and sides of
the crate.
- Lift out the Billboard, two L-brackets, and Joint Plate and
set aside in a protected location.
- Lift the Cash Box Tower out and set near its approximate
installation location between the left- and right-side cabinets
(see Figure 2).
PREPARE CABINETS AND TOWER FOR ASSEMBLY
- Unscrew and remove the rear cover of the Cash Box Tower and
set the cover aside.
- Untape the wire harnesses from the outside of the inner panels
of the left and right-side cabinets and the outside of the Cash
Box Tower (see Figure 2).
- Peel the blue protective covering off all silver trim strips
on both left- and right-side cabinets.
- Remove the upper two bolts and split washers from the outside
of the inner panel of the left and right-side cabinets. Keep
these bolts and washers available.
- Loosen approximately 1/4 inch the lower two bolts on the
outside of the inner panel of the left and right-side cabinets.
Do not remove the lower two bolts.
FIGURE 2: REAR VIEW, ASSEMBLED INDY 500 TWIN CABINET