[Table of Contents] [Previous Page] [Next Page]

16. TROUBLESHOOTING

In case a problem occurs, first check wiring connector connections.

PROBLEMS

CAUSE

COUNTERMEASURES
When the main SW is turned ON, the machine is not activated. The power is not ON. Firmly insert the plug into the outlet.
Incorrect power source/voltage. Make sure that the power supply/voltage are correct.
The CIRCUIT PROTECTOR functioned due to momentary overcurrent. Reset the AC Unit's Circuit Protector.
PTV screen color is not correct. Screen adjustment is not appropriate. Make adjustments appropriately.
PTV screen has a color deviation. Affected by the periphery, such as other machines, location building's steel frames, etc. Make convergence adjustments.
Change installation direction/position.
Move the other machines which cause the problem.
No image is projected on the PTV screen. Connector connection is incorrect. Check connector connection inside the Roof Lid and Front Panel L.
Sound is not emitted. Sound volume adjustment is not correct. Adjust SW Unit's speaker volume.
Malfunctioning BD. and Amp. Perform sound test to check it.
Connector connection is incorrect. Check the connector connection inside the Roof Lid.
Woofer sound is not emitted. Sound volume adjustment is incorrect. Adjust SW Unit's woofer volume.
Connector connection is incorrect. Check connector connection inside the Roof Lid, and Front & Rear cabinets.
Operation of Accel., Brake and Pedal are not satisfactory. V. R. position deviated. Adjust V. R. value in the test mode.
V. R. malfunctioning. Replace the V. R.
ADJUST GEAR's engagement is not correct. Adjust the engagement of ADJUST GEAR.
SHIFT LEVER doesn't operate satisfactorily. Switch malfunctioning. Replace the SW.
Steering Wheel reaction strength is incorrect. Deviation of Center. Power ON check not performed correctly. Turn off power and then turn it back on again. Complete the power on check.
V R. position deviated. Adjust V. R. value in the test mode.
V. R. malfunctioning. Replace the V. R.