[Previous page][Next page][Table of Contents]

10 - 2 MITSUBISHI MONITOR

For the Convergence adjustment mode, press the test mode on/off key. 12

Ensure that "R" is displayed on the screen.

Make adjustments so as to cause the red cross pattern to match with the green cross pattern by using Left shift key 14 , Right shift key 15 , Lower shift key 16 , and Upper shift key 17 .

By using R/B shift key 13 , cause the red adjustment "R" to shift to blue adjustment "B" and make sure that "B" is displayed on the screen.

In the same manner as in 3 above, cause the blue cross pattern to match with the green cross pattern.

After making adjustment, press the test mode on/off key 12 to cancel the convergence adjustment mode.

STATIC CONVERGENCE ADJUSTMENT METHOD WITH REMOTE CONTROL

Although Remote Control Buttons other than those specified below do not function even if pressed during Convergence Adjustment, do not press them during adjustment work so as to avoid causing malfunctioning.

Operate the Remote Control towards the PTV screen. If directed other than to the PTV screen, the Remote Control does not function.

BEFORE USING REMOTE CONTROL:

First make sure that the main SW on the Projector's control panel is ON (the LED adjascent to the main SW is lit).

The Remote Control has 2 different types. Depending on the type, the Adjustment procedure is different.

For the Convergence Adjustment mode, press the test button. Ensure that "R" is displayed on the screen.

Make adjustment so as to cause the red cross pattern to match with the green cross pattern.

When the red cross matches the green cross, the green cross turns yellow or white.

Use remote control buttons shown below to move the red cross as follows:

Button to the left.......5

to the right................7

Upward....................2

Downward..............10

Use Remote Control button 6 to shift "R" to "B". Make sure that "B" is displayed on the screen. Each time Button 6 is pressed, red and blue adjustments are shifted.

In the same manner as in 2 above, cause the blue cross to match the green cross. When the blue cross matches the green cross, the green cross turns white.

After adjustment is made, press the test button to cancel the Convergence Adjustment mode.

*When 2 minutes or more elapses in the Convergence mode screen without taking any action, the on-screen adjustment mode will disappear.

In case of REMOTE CONTROL (Part No. 200-5532):

Press the TEST KEY to have the red line adjustment screen appear.

Superimpose the red cross on the green cross at the center of the screen.

Move the red cross to the left, right, up, and down respectively with the corresponding buttons of the remote control.

When the red cross is superimposed on the green cross, the green cross turns into yellow or white.

Press the R/B Key to have the blue line adjustment screen appear. Each time R/B Key is pressed, the red line and blue line will be alternated.

In the manner similar to 2 above, press each key to superimpose the blue cross on the green cross. When it is superimposed, the cross in the center will become white.

Press the TEST KEY to exit from the adjustment mode.

During STATIC CONVERGENCE Adjustment Mode, if no action is taken within 5 minutes, the adjustment mode will be exited automatically.