Do not touch places other thanthose specified. Touching places not specified can cause an electricshock or short circuit.
Loosen the 2 screws which secure the VR bracket in order to movethe bracket.
Move the VR bracket to disengage the adjust gear mesh and movethe VR shaft in a manner so that the VR shaft cut portion facesthe opposite side of the adjust gear as shown.
Have the gears meshed and tighten the two screws.
Slowly swing the controller up and down, left and right to checkif the value exceeded the VR mobile range.
After finishing adjustments, be sure to set sights on the aimset screen in the test mode.
In order to prevent an electricshock and short circuit, be sure to turn off power before performingwork by touching the interior parts of the product.
By removing the cord clamp, first remove the VR blue 3P for up/downand VR red 3P for left/right. Take off the two screws which securethe VR bracket to remove the bracket.
Remove volume gear from the VR to replace the VR.
After replacing the VR, perform work by following the procedureas per VR adjustment.