STOP: IMPORTANT!
Although Remote Control Buttons other than those specified below
do not function even if pressed during Convergence Adjustment,
do not press them during adjustment work so as to avoid causing
malfunctioning.
Operate the Remote Control towards the PTV screen. If directed
other than to the PTV screen, the Remote Control does not function.
BEFORE USING THE REMOTE CONTROL:
First make sure that the main SW on the Projector's control panel
is ON and the LED adjacent to the main SW is lit.
For the Convergence Adjustment mode, press the test button. Ensure
that "R" is displayed on the screen.
Make adjustment so as to cause the red cross pattern to match
with the green cross pattern. When the red cross matches the green
cross, the green cross turns yellow or white.
Use remote control buttons shown below to move the red cross.
(5) .......... to the left.
(7) .......... to the right.
(2) .......... Upward.
(10) ........ Downward.
Use Remote Control button (6) to shift "R" to "B."
Make sure that "B" is displayed on the screen. Each
time Button (6) is pressed, red and blue adjustments are shifted.
In the same manner, cause the blue cross to match with the green
cross. When the blue cross matches, the green cross will turn
white.
After adjustment is made, press the test button (Figures 1 - 5
below) to cancel the Convergence Adjustment.
When 2 minutes or more elapses in the Convergence mode screen
without taking any action being taken, the on-screen adjustment
mode will disappear.