CAUTION! Since the projector has been adjusted at the
time of shipment, do not make any further adjustments without
good reason.
Fine adjustments are stored in the projector. Pressing the fine
adjustment switch (Convergence adjustment) results in entering
the fine adjustments mode, and this may cause the stored fine
adjustment to be changed. During work other than for adjustment,
should you touch the fine adjustment switch by mistake, immediately
turn off power by using the main switch and then turn it back
on again. If any distortion or color deviation is found in the
test mode, and adjustments are needed, use the specified adjustment
knob or perform the adjustments by using the remote control. Note
that projector models and makes may vary, and adjustment methods
will differ dependent on the manufacturer.
STOP: IMPORTANT! The projector is subject to color deviation
due to convergence deviation caused by geomagnetism at the installation
location and peripheral magnetic field. After the installation
of machine, and before commencing operation, check for convergence
deviation and, if deviated, make necessary adjustments.
CAUTION! Since the projector screen is highly susceptible
to damage, pay careful attention to its handling. When cleaning,
refrain from using water or volatile chemicals.
When the screen surface becomes dirty with dust, etc, clean it
using a soft cloth such as gauze. When water and volatile chemicals
such as benzene, thinner, etc, spill onto the the screen surface,
it may be susceptible to damage, therefore, refrain from exposing
the surface to these liquids. Also, since the screen surfaces
are easily susceptible to damage from abrasion, avoid rubbing
them with any hard materials or using a duster.