[Table of Contents] [Previous Page] [Next Page]

Bring the PTV and cabinet close together with an approximate distance of 30 cm. between them.

By using the 4 accessory wires, perform the wiring connection between the PTV and the cabinet. Insert the red, green and blue wiring connectors to the corresponding R, G and B terminals, and insert the remaining wire connector to the SYNC terminal.

The connector's insertion angle is predetermined. Inserting the connector in a forcible manner will damage the connector. Determine the correct angle of insertion before attempting to insert the connector. After insertion of the connector, turn the connector ring to the right to lock the connection

STOP: IMPORTANT!
Ensure that the wiring between the PTV and Cabinet DX is via the path shown. If the wiring passes a path other than the one shown, the cabinet cannot be assembled.

The PTV connector panel has a 3p white connector, apart from the connectors displayed as R, G, B and SYNC. Connect the wiring from the power supply unit to the 3p white connector.

Connect the opposite end of the wiring (which is displayed as R, G, B and SYNC) to the corresponding R, G, B and SYNC terminals of the VPM buffer board in the cabinet. By turning the connector ring to the right, lock the connection for the 4 connectors inserted to the board.