[Previous page][Next page][Tableof Contents]
10. MAINTENANCE OF MECHANISM UNIT
10 - 1 ADJUSTMENT AND REPLACEMENT OF VOLUME
Be careful so as not to damage wirings. Damaged wiring can cause an electric shock or short circuit accident.
Do not touch places other than those specified. touching places other than thos specified can cause electric shock or short circuit accident.
When performing work, be sure to use plural workers. Working by a single worker alone can cause accidents and parts damage.
This work should be performed by the Location's Maintenance man or Serviceman. Performing work by non-technical personnel can cause shock hazard.
Enter test mode to check the Volume value. Work is performed inside an energized cabinet. Use care so as not to touch undesignated places. Failure to observe this can cause electric shock and short circuit hazards.
(1) In the Test Mode, have the volume value displayed on the screen.
(2) Move the seat to the foremost position and remove the 4 bolts which secure the seat.
(3) Another person is to incline and hold the seat so that the Volume can be checked.
ADJUSTING THE VOLUME
(1) Loosen the 2 screws which secure the Volume Bracket, and move the Bracket.
(2) Move the Volume Bracket to disengage gear mesh.
(3) With the front part of Cockpit inclined up to the top position, adjust gear mesh to ensure the volume value display is within the range of 80+/-10H.
(4) Fasten the 2 screws which secure the Bracket.
(5) In the Cockpit Reaction Test Mode, check the volume value.
(8.) Remove the gear from the Volume Shaft and replace the Volume.
REPLACING THE VOLUME
(1) Turn power off.
(2) Disconnect the connector.
(3) Take out the 2 screws which secure the Volume Bracket, and remove the Volume Bracket.
(4) Remove the Volume Gear and Volume Bracket to replace the Volume.
(5) After replacing the Volume, adjust the volume value by using the above procedure.
10 - 2 GREASING
In order to prevent an electrical shock and short circuit, be sure to turn power off before performing work by touching the interior portions of the product. When performing work, be sure to use plural workers. Working by a single worker alone can cause accidents and parts damage.
Be sure to use the designated grease. Using undesignated grease can cause parts damage. Do not apply greasing to places other than those specified. greasing to undesignated portions can cause malfunctioning and the qaulitative deterioration of parts.
Once every 3 months, apply greaisng to the following places. For spray greasing, use GREASE MATE (PART No. 090-0066).
Take out the 8 screws, remove the Mecha Cover, and applygreasing.
GREASING TO THE SPRING PORTION UNDERNEATH THE SEAT
Once every 3 months, apply greasing to the 2 Spring and Spring installation portions underneath the seat. Remove the 4 bolts which secure the seat, and for safety, one person is to incline the seat and another person is to apply greasing.
10 - 3 REPLACING THE SAFETY RUBBER
The Safety Rubber is an important, hazard-prevention part. Before commencing daily operation, be sure to check for damage and omission. Operating with the Safety Rubber as is damaged or omitted can cause the customer's fingers to be caught.
INSTALLATION OF RUBBER MIDDLE SIDE
To install RUBER MIDDLE SIDE to the side oppisite the Cockpit, turn over the RUBBER and use HOLDER LEFT S.
