Choosing Drive Board Test allows the reaction mechanism of the steering wheel to be checked. Also, this enables the VR value for the steering wheel's drive board and the settings of the dip switches on the drive board to be checked.
Bring the arrow -> to the desired item by using the service switch or VR1 (red) or VR4 (green). The steering wheel functions to the setting selected by the arrow. Pressing VR2 (blue) or VR3 (yellow) allows the force transmitted to the steering wheel to increase or decrease.
SPRING - Status in which the motor and clutch are not activated. Centering of the handle is caused by only the spring inside the handle mechanism.
CLUTCH - Status in which the clutch is activated. The handle is fixed.
CENTERING - Status in which the handle returns to the center position by itself.
UNCENTERING - Status in which the handle is caused not to be in the center.
ROLL LEFT - Status in which the handle is rotated in the left hand direction.
ROLL RIGHT - Status in which the handle is rotated in the right hand direction.
EXIT - Returns to the menu mode.
HANDLE - Displays the Handle VR value. Make sure that the appropriate VR value is as follows:
DIP SW - Displays the setting status of dip switches on the drive bd.
DIP SWITCH SETTING TABLE
The setting of the dip sw nos 1-4 on the drive board allows the handle's weigh (feeling) to be set and ON or OFF of the power on check to be selected. Dip sw nos 5 and 8 are to be off.
Note: Shaded portion refers to the settings at the time of shipment.
When dip sw changes are made, be sure to turn the power off and then back on again. The new setting will not be effective unless power is turned off then on.
The handle's reaction mechanism is subject to change. When the reaction becomes lighter, change the dip sw setting.
DRIVE BOARD ERROR DISPLAY
When malfunctioning occurs in the drive board, testing will not be performed even if the drive board test is selected. In this case, the error will not be displayed by the 7-seg display on the drive board.
Also, when power on check error occurs, the 7-seg display data repeatedly flashes. First, check the handle mecha's VR, the motor, clutch, etc.