|
PROBLEMS |
CAUSES |
COUNTERMEASURES |
|---|---|---|
| When the main SW is turned ON, the machine is not activated. | The power is not ON. | Firmly insert the plug into the outlet. |
| Incorrect power source/voltage. | Make sure that the power supply/voltage are correct. | |
| AC UNIT CIRCUIT PROTECTOR functioned due to instantaneous overcurrent. | First, remove the cause of overcurrent and reinstate the circuit protector to it's original status (refer to Sec. 6). | |
| MONITOR screen is blackened and the fluorescent lamp does not light up. | Power supply unit fuse blown off due to instantaneous overcurrent. | First remove the cause of overcurrent, then replace the fuse
(refer to Sec. 17). FUSE 10A 250V |
| MONITOR screen is all blue. | Defective connections in between each board. | Make sure of correct connections in between each board. |
| The color of image on MONITOR screen is incorrect. | Incorrect monitor adjustment. | Make appropriate adjustments (see Sec. 13). |
| The on-screen image of the monitor sways and/or shrinks. | The power source and voltage are not correct. | Make sure that the power supply and voltage are correct. |
| Control panel and pedal are not satisfactorily operable. | V.R. position deviated, or V.R. malfunctioning. | Adjust or replace the V.R. (see Sec. 9 & 10). |
| ADJUST GEAR's engagement is not correct. | Adjust the engagement of ADJUST GEAR (see Sec. 9 & 10). | |
| SHIFT LEVER doesn't operate satisfactorily. | Switch position deviated, or switch malfunctioning. | Adjust or replace the Switch (see Sec. 11). SW MICRO TYPE |
| Steering Wheel reaction strength is insufficient. | POWER ON CHECK not performed correctly. | First turn the power off and then turn it back on again. Complete the POWER ON CHECK. |
| V.R. position deviated, or V.R. malfunctioning. | Adjust or replace the V.R. (see Sec. 9). | |
| Reaction mecha's secular change. | Change DRIVE BD DIP SW setting (see Sec. 8 & 17). |