In the TEST MODE, ascertain that the assembly has been made
correctly and IC BD., is satisfactory (refer to Section 8).
In the test mode, perform the following test:
Selecting the MEMORY TEST on the test mode menu screen causes
the on-board memory to be tested automatically. The game board
is satisfactory if the display beside each IC No. shows GOOD.
Selecting the INPUT TEST on the test mode menu screen causes the
screen (on which each switch and V.R. are tested) to be displayed.
Press each switch. For the coin switch test, insert a coin from
the coin inlet with the coin chute door being open. If the display
beside each switch indicates "ON", the switch and wiring
connections are satisfactory.
Ascertain the display of V.R. value for the steering wheel and
accelerator & brake. If the V.R. values are not satisfactory,
refer to Sections 9 & 10.
In the TEST mode menu, selecting OUTPUT TEST allows the screen
(on which the monitor is tested) to be displayed. Although the
monitor adjustments have been made at the time of shipment from
the factory, make judgment (by watching the test mode screen)
as to whether an adjustment is needed. If it is necessary, adjust
the monitor by referring to Section 13.