[Table of Contents] [Previous Page] [Next Page]

11-2 REPLACEMENT AND ADJUSTMENT OF SWITCH

Method of replacement

  1. Disconnect the wiring connector of the SW to be replaced.

  2. Take off the 2 screws which secure the BRACKET (SW BRACKET A & B) to which the SW is attached, and remove the SW together with the bracket. (FIG. 11.2)

  3. Take off the 2 screws which secure the SW, and replace the SW.


FIG. 11.2

  1. To secure the replaced SW to the bracket, incline it as shown (FIG. 11.3). Securely fasten the screws by applying an anti- loosening agent to the screws.

  2. Install the SW bracket with 2 screws. When installing SW BRACKET A, an adjustment in the following procedure is required.

  3. After SE replacement, check the SW input in the test mode.


FIG. 11.3

Adjustment to be made at the time of installing SW BRACKET A

  1. Shift to the first or second gear.
  2. At this time, secure SW bracket A with 2 screws in a manner so that the SW attached to SW Bracket A is caused to be ON.